Brick Copings and Sills Fayetteville NC

A brick is called a rowlock when it's laid on its face edge. Though many owners in Fayetteville and architects find rowlock brick copings and sills in Fayetteville appealing, they should be avoided in exterior applications.

Mcdonald Lumber Co
(910) 483-0745
Po Box 2185
Fayetteville, NC
 
Cumberland Tractor Co
(910) 483-3892
127 Dunn Rd
Fayetteville, NC
 
Neff Rental
(910) 323-3418
140 Pepsi Ln
Fayetteville, NC
 
Highland Lumber Co Inc
(910) 483-1391
325 Blount St
Fayetteville, NC
 
Southland Rental & Supply Co
(910) 323-5300
2246 Angelia M St
Fayetteville, NC
 
South Atlantic Traffic Company
(910) 223-3163
2018 Fort Bragg Rd
Fayetteville, NC
 
Cameron & Barkley Co
(910) 321-3141
345 Wilkes Rd
Fayetteville, NC
 
Tarheel Supply
(910) 483-2678
228 Robeson St
Fayetteville, NC
 
Hertz Equipment Rental
(910) 483-9666
608 Middle Rd
Fayetteville, NC
 
Sunbelt Rentals
(910) 323-4416
318 N Eastern Blvd
Fayetteville, NC
 

Brick Copings and Sills

Provided By:

Source: MASONRY CONSTRUCTION MAGAZINE
Publication date: December 1, 1990

I have heard that rowlock brick copings and brick sills should not be used. Is this true? If so, why not?
A brick is called a rowlock when it's laid on its face edge. Though many owners and architects find rowlock brick copings and sills appealing, they should be avoided in exterior applications. Brick rowlock copings contain many more horizontal joints than do concrete, stone, or metal copings. Each of these joints provides a potential entry point for water. Because of this, many brick sills and copings deteriorate after several freeze-thaw cycles.If rowlock brick copings or sills are used, they must be flashed. Place flashing underneath the coping or sill. Extend it beyond the face of the masonry and bend the projected edge down 1/4 inch to form a drip. Seal any penetrations through the flashing, such as anchors. Install weep holes at the level of the flashing at 16 inches on center for wicks and 24 inches on center for holes and tubes. Also, slope the copings or sills to prevent water from sitting on the surface. For brick sills, the Brick Institute of America (BIA) recommends a minimum slope of 15 degrees (Technical Note 36, "Brick Masonry Details: Sills and Soffits").

Click here to read full article from Masonry Construction